On the lime kiln process management to strengthen management, improve predictability, stability operations, a reasonable match wind, fuel, materials and production conditions to stabilize the kiln, the thermal stability of the system, always pay attention to changes in fuel, timely adjustment of operating lime green kiln feasibility report, to avoid an accident or operation process accidents. Steel kiln shell in the design and construction of the installation should pay attention to the following points, a kiln shell welds shall be continuous welds and must weld. 2. Any ovality section should not exceed 25 mm. 3, the height of the center of the inclination of the kiln shell should be no greater than 20 mm. 4, the actual length of the outer circumference of the kiln shell length and calculate the deviation is not more than 5 mm 5, vertical and horizontal position deviation weld plate edge should not be more than one millimeter at 6 in the kiln shell, vertically adjacent longitudinal welds should be staggered environmental lime kiln, a distance of not less than 200 mm. Vertical kiln production is often due to raw materials, defective fuel calcining kiln operation control and to determine the status of the deviation, will appear in the kiln wall tumor mass phenomenon, and even shed material phenomenon. This phenomenon can also cause kiln wall temperature increases, there will be serious coal-burning kiln wall to see red lime green cost, but also a refractory failure phenomenon. After this happens, must be treated, otherwise it will seriously affect the safe operation of the quality of the lime kiln and lime. Kiln shell of reinforced concrete and steel kiln the forces shell the same, but because of this kiln shell thickness than the steel shell large coal burning kiln lime green offer, and therefore needs to withstand the temperature difference between inside and outside temperature stress generated when the computer passed to concrete When the temperature of the kiln shell, should be considered complete when the brick lining and wear after two cases, because the brick lining wear will raise the temperature inside the kiln shell surface. From the perspective of temperature stress, temperature kiln thinner reinforced concrete shell, the temperature difference between the inside and outside of the stress caused by YU Xiao, but the kiln shell is too thin is not easy to ensure construction quality. Taking into account the complexity of the kiln shell by force and to ensure the quality of construction, it is generally preferable to 150 mm thickness, when the kiln shell height is small, its thickness can be reduced to 120 mm. Environmental cost of burning coal kiln, lime green, Kim Kim furnace provided by Kiln Ltd. Linyi City. Linyi Kim Kiln Ltd. (www.dfyaolu.com) (www.dfyaolu.cc) strong, credible, Shandong Linyi environmental protection equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Kim kilns and you hand into the brilliant, for a better future!